Dust collection system design - need advice
I've just recently purchased a new dust extractor - a Sherwood 2HP Cyclone Dust Extractor and I'm in the process of designing my hard-piped system.
The question is do I run 100mm everywhere (cheap, readily available) or keep it in 125mm until I get to the tool?
125mm piping is definitely not as common and the best option I can find is steel range hood ducting which is about 10x the cost of 100mm PVC when you consider the cost of elbows and fittings and the steel fittings are definitely harder to install.
Obviously I'd prefer 100mm but I don't want to do that and regret the decision!