3 Attachment(s)
Adjustable 12 V DC Timer Relay Wiring
Members, seeking any advice about how to wire this unit. The purpose is to operate an automaton which is equipped with a 12V DC motor. At the press of the ON button, the unit powers on for around 35 seconds, disconnects. The cycle can be repeated. Experimented with the wiring, without success, cannot power the motor. I am missing something, due to very limited understanding of electronics. Any assistance would be greatly appreciated.
Should the + input be also connected to the center terminal of the NO - NC block ? Should T1 be turned more or less off, then T2 be adjusted to 35 seconds ? The Red led is on, as is the green, but no current detected at the output block.
Regards,
Gus