Sealing around shower head / bathroom fittings...

Printable View

14th November 2009, 10:40 PM
Reno RSS Feed

Sealing around shower head / bathroom fittings...

Ok guys... Just about finished my bathroom reno and its looking tops!

Soon will need to attach the plumbing fittings... showerhead, mixer handle/plate etc...

Question is, the gap where the pipework for the shower head and mixer comes through the tile, does this just get filled with silicone to seal that off so any water that comes in behind fitting plates/rings/washers etc cannot get in behind the tile/wallboard etc?

Read the full thread at RenovateForum.com...

All times are GMT +11. The time now is 04:01 PM.

Search Engine Optimisation provided by DragonByte SEO v2.0.42 (Pro) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Copyright © U-Beaut Enterprises 1999 - 2016. All rights reserved.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.