Yep I've it the same problem
Quote:
Originally Posted by
catpower
Hi guys hope someone can help with this problem,my lucas mill will not cut properly vertical and horizontal cuts do not meet to make a clean cut and it starts to dig into the timber and wander all over the place,took the blade to sawshop they sharpened it and said it was good to go.
Heres some photos.:?
Ive done all the adjustments and just can't get my cuts to meet. What happens is the blade flicks to the left about 10 mm when it exits the vertical cut, so it's being pit under pressure. Then, once I dod the hoz cut, the blade jams towards the last third of the log and when it exits, the hoz cut is about 8mm below the vertical cut line.
Will try another blade because I do use my mill to rip posts and do so without the guard/water bottle so it may have gotten too hot.