5 Attachment(s)
Wadkin PK Saw with Table Extension
This fine unit has been in the family for many years and in Geelong for many years prior to our purchase.
PK 1277 dates from late 1930s according to Wadkin and I thought to document a few chronological features.
Type ZF non fully enclosed motor
Rubber coated wiring
Brookhirst motor control (pre Wadkin Controls)
Early On/Off buttons
Rip fence large adjuster knob not knurled
This saw lacks the cross cut fence and the table in fill strips (the cross cut fence was obviously used frequently)
but is other wise complete including complete outrigger with 6 foot ruler.
I have a couple of other Wadkin units and find the engineering to be magnificent; hence the long life.
CheersAttachment 240785Attachment 240786Attachment 240787Attachment 240788Attachment 240789
10 Attachment(s)
PK crosscut table extension
Here are some further shots of the outrigger and pylon.
The pylon and table ext are very heavy(made by Wadkin) and the pylon is unstable;bolt down well unless you wish to undergo foot surgery.
The extension runs on two unshielded ball bearings with oil holes;the angle iron beam can be adjusted for level with two screw adjusters in the pylon.
The ext table is fitted after removing the horizontal push handle on the sliding table.
Two bolts hold the extn to the slider and allow a little adjustment room.
I mounted my pylon to allow more workshop space but neglected to allow for the lateral movement of the slider (blade removal etc.)
The fence has allowance for some low angle work with an arc of threaded holes for the outboard clamp.
The six foot ruler for the fence is one inch square rod with marked gradations(Heavy).I dont leave this on the saw as it is at the right height and outward extent to remove testicles easily.The pylon can cause a heavy thigh bruise for the unwary.