Good day gentlemen.
I came across a Algra rapidue QCTP in a previoius post and have set it up on my Al60G where its working well.
There was only one toolholder and a boring bar holder with it, and at the time I didn't care.
Now I'm at the stage of wondering if I might source some more tool holders, mostly for the 'hell of it', since changing tools in the holder (as if its not a quick change set up) has not seemed to be problem.
The Tipo M holders seem to cost about $100 each from the little bit of research I've done, so I'm wondering if there's an alternative. (apart from making them, which would stretch my capabilities at the moment)
I recall someone saying that Dixon toolholders might fit, but even they seem costly, and I don't have the knowledge to know if there are different sizes etc.
Is there a economical alternative with the same profile toolholdes as Algra? Maybe from Asia?
I'm aware that it may be akin to fitting holden parts to a rolls royce, but for the home garage usage I have for the lathe, and if it takes a little hand filing or shaping to make things tight, I'm up for that.
Don't get me wrong, I don't use shifters or a hammer, I'm not that rough, but 'good enough' works sometimes if I have patience and care.
And while my tongue may be in my cheek (a little) I really will appreciate any suggestions and advice please.
warm regards Brian