Hey guys. Just working out what I need to get started on a mill/drill conversion. No problems with the mechanical side but not real sure on the electrical side. Outside of a few pics and a couple of schematics I found on the internet I'm still a little confused.#I'm using a G540 controller as in the schematic bellow. Most of it I can follow but I'm a little lost at the switch/relay end of the circuit.
http://www.homanndesigns.com/pdfs/EN010_V8.pdf
So mains power comes in through a cable connected to SW-06 (IEC plug/switch/fuse)? Then goes through the e-stop and to the power supply? Another line goes off to the relay and powers IEC female socket?
What is IEC female socket used for? To power the computer or something else?
What is the 'auxiliary relay output' thing off to the side and what is the enable switch used for?