New Mill

first up I am affiliated with product(Vic agent)

Milled this small section of log (Crapiata) whilst over in NZ last week testing out the new 8" swing mill as there were still a few teething problems which were sorted by the end of week. When cutting the full 8 inch on the horizontal cuts we were getting a little bounce back but none on the verticle. All fixed noe though.
Using a huski 395 cut 6x2s and some 6x1s this was just one tanks worth of fuel.
I am eagerly awaiting delivery of mine.

That's a big ask to get 94 cc to push a full 8" horizontal cut, I can't get 747 cc to push a full 8" cut