show me your necklace tooling . Chain mortising ?
One of the chain and bars I got with My Stenner BL mortiser was one of the small gauge chains. can't remember the numbers for the 3 chain pitch sizes. I have never been able to run it though as it was missing the sprocket. had some one in the US quote me $150 for an old stock sprocket and thought it was to rich for my bottom feeder blood.
There was/is some tooling on the block up in the UK most of it old Reynolds Wadkin/ Robinson tooling, and i grabed this German necklace. I did the Buy it now as you just don't see these very often AND BEFORE I COULD THINK ABOUT. In fact i have never seen them come up . so for 75 GBP for the set i had to adjust my bottom feeder ways and click sold.
Any one know if that's a grease fitting or for an auto oiler?
http://i927.photobucket.com/albums/a...psfcfccb2c.jpg
bar looks real good to me?
http://i927.photobucket.com/albums/a...psd8df9b5c.jpg
any one seen or have any of the specal Wadkin doubles or triangle kits?
http://i927.photobucket.com/albums/a...psd4ffcae5.jpg
Looking for advice on handling this smaller chain tooling from users.
jack
English machines