Tormek leather wheel LA-220 actually is 215mm

Printable View

16th September 2017, 04:22 PM
KnifeGrinders

Tormek leather wheel LA-220 actually is 215mm

After we found out the Tormek honing leather wheel LA-220 actual diameter is 215mm, we started a discussion on the Tormek forum, with some interesting responses from Tormek.

https://www.tormek.com/forum/index.php?topic=3361.0

Not sure if this is news to the Tormek community, but actual honing wheel LA-220 diameter is 215 mm.
If you set your honing angle at the 220 mark that is in bold on the AngleMaster, you will inevitably round the edge.
Correct is setting it at 215 mark - as shown by the red line on the photo:

http://knifegrinders.com.au/photos/AngleMaster.JPG

All times are GMT +11. The time now is 12:27 AM.

Search Engine Optimisation provided by DragonByte SEO v2.0.42 (Pro) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Copyright © U-Beaut Enterprises 1999 - 2016. All rights reserved.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.