Can't find a 11.25 degs chamfer/bevel bit with 1/4" shank
Hi all, sometime lurker but haven't jumped on these forums in about 4 years!
I'm doing a little project which will be essentially a hardwood cylinder with 16 strips of timber.
Being 16 pieces around the circumference, I need to get an exact 11.25 degrees which will no doubt be difficult on my Triton saw bench - the slot is too narrow anyway to angle the blade.
So rather than using the saw, I can just get a router bit with a 11.25 degree chamfer.
I scoured the internet high & low and all the bits are 1/2" shank. My router takes 1/4" shanks.
Anyone know where I can get a 1/4" shank router bit with a 11.25 deg chamfer?
Alternatively I can use a dovetail bit, but they all seem to be 10 degrees or 14 degrees. That may be my best alternative as I could just use 18 strips to make the cylinder. That means I can use a 10 deg dovetail bit to chamfer the edges.
Thx all