Trailer with onboard brake system blowing fuses

Printable View

14th August 2018, 12:50 PM
MWF FEED

Trailer with onboard brake system blowing fuses

Have a trailer here with an on board brake controller.

Issue is the plug was rewired (not by me) and while it looks OK, when you apply the brakes in the towing vehicle, the trailer wheels brake momentarily, then the brake fuse in your vehicle blows.

How are electric brakes supposed to be wired up?

The controller installed is the same as this one

https://www.ebay.com.au/itm/Brake-Co...-/323078407323

Read and reply to the full thread at metalworkorums.com....

All times are GMT +11. The time now is 05:43 PM.

Search Engine Optimisation provided by DragonByte SEO v2.0.42 (Pro) - vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.

Copyright © U-Beaut Enterprises 1999 - 2016. All rights reserved.

This website and its content is copyright of U-Beaut Enterprises.
Any redistribution or reproduction of part or all of the contents in any form is prohibited other than the following:

♦ you may print or download to a local hard disk extracts for your personal and non-commercial use only
♦ you may copy the content to individual third parties for their personal use, but only if you acknowledge
Woodwork Forums as the source of the material.

You may not, except with our express written permission, distribute or commercially exploit the content.
Nor may you transmit it or store it in any other website or other form of electronic retrieval system.