-
Woodfast 280 pulley belt
I have an old Woodfast 280 lathe still running well except the pulley belt has given up the ghost.
I cannot find anything on the net about a suitable pully belt.
It is a 3 ribbed belt approx. 13 inches long.
Does anyone know where I could get one or a similar one that would do the job.
Thanks
Don
-
Don, take the worn out belt to a bearing/bolt shop. They can measure your original belt and sell you one that will fit. You might have to visit an industrial area to find the shop
-
don, contact graham at woodworking solutions in south australia. apparently the are two different belts for that model lathe. i ordered some of him about three months ago. sent return post and cost about $27
cheers
jim
-
Thanks chambezio but not in Grafton.
-
-
[QUOTE=Don Nethercott;211259Thanks chambezio but not in Grafton.[/QUOTE]
Hi Don , you might have to go a bit further than Grafton :oo:
Measure the belt and try Boambee Industrial Supplies ....
(BISCO) in Cook Drive Coffs Harbour , they have hundreds
Of belts hanging from the roof , give them a ring they are
very helpful and will send it by courier , same day !