5 Attachment(s)
Getting there - Outtable for Hyco saw
Lot of head scratching, we're getting there... Having the adjustable deck helps, but there was a miscalculation on the belt and motor position.
Attachment 446678
Attachment 446679
The motor has to sit up quite close to the saw to get the belt under and clear of structural support... And still deciding on what to use for the deck.
Attachment 446680
Attachment 446681
Power and safety
Attachment 446682
4 Attachment(s)
Into the bench and motor mounting concerns
We're getting close but the motor mounting has me stumped. Do the belt driven tables have belt tensioners or side on a movable mount. Because if I raise the saw, I'll add tension to the belt. If I lower it is will loosen.
I thought of raising the motor slightly to decrease the change in pulley and belt angle but that then has the belt very close to the underside of the table. More head scratching... but all is good.
I've also succumb to deferring any splitter/riving solution for now. To get the motor mounted I had to remove the splitter mount to get the motor close enough. there's some wiggle room in future. There's also not enough end room on the zero plate to use MJ Splitters... I'd have to drill into the deck I think.
Attachment 446715
Attachment 446716
Attachment 446717
Attachment 446718
Advice appreciated in advance