Extension tables on the Hammer A3-31
Been using the machine a lot over the festive period and very much loving the bang on accuracy it provides. I have come across something odd hence the following query.
I have 1x short extension table ( which I plan to move around the unit as I require it) I purchased extra mounts for it and have attached these to both the jointer outfeed and also the planer outfeed. The aluminium extension table slides onto the mount from either side then it locks from below using the plastic handle. That works fine on the jointer table - yet there is no room on the planer table to slide it onto the mount from the side as the planer table is located inside the main guts of the machine. I've had to dissasemble the locking mechanism on the extension table - hang it onto the mount - then re-assemble the locking mechanism while it's now in place. Is that what is required or am I being thick and have missed something obvious. Can't see me moving the extension table on and off the planer if that is the case and I might just buy one to fix it on permanently if required. Thanks for the input
Ged