Hi all .. Had this in the general section.. some may already have seen it..I need to reproduce this nut for a vintage vice I am working on.. thread diameter is 7/8" or 22.2 mm.. pitch is just over 4 turns to the inch..
because of the mystery number of turns, and as it is brass, would it be possible to cast a new nut around the screw ???
Ken100_3138.jpg100_3140.jpg100_3137.jpg
Attached Images
- http://metalworkforums.com/images/attach/jpg.gif 100_3138.jpg (132.0 KB)
- http://metalworkforums.com/images/attach/jpg.gif 100_3140.jpg (153.0 KB)
- http://metalworkforums.com/images/attach/jpg.gif 100_3137.jpg (120.4 KB)
Read the full thread at metalworkforums.com...