Sherwood Bandsaw problems
I purchased an 18" Sherwood Bandsaw from Timbecon a couple of years ago, all up I've probably cut in total 5 metre length of timber ( some short, some very short up to a metre ) not very much use at all. The problem I'm having is setting/adjusting the blade.
The biggist of the blades was installed when I got it and purchased 3 x other smaller blades at the same time. The large blade worked pretty well. Then I tried putting the smallest of the blades on, only about a cm wide and the adjustment gets nowhere near to tightening it.
It's as if Timbecon gave me a blade that was 1" or so too long. I had a friend come around and we tried the 2nd smallest blade which only very just tightened to a useable touch, you couldn't get another part turn on the adjusting knob. All looked good, we ran the saw for a few secounds all was keeping in the middle of the two wheels so we released the tensioner lever at the back and left it.
About a fortnight later I had big plans to cut up a burl, pulled on the tensioner lever and it in no way would tension the blade. I tried the adjustments to the maximum it would go which was well past the blade gauge size tensioning guide and wouldn't tighten any further,, result = still loose, it's as if the blade somehow grew/stretched a couple of inches and will not tighten. I'm really off as it is well out of any warranty that came with it now.
I was hoping there is someone with a lot of Bandsaw experience living in the Mandurah area that wouldn't mind dropping around and have a look at this bloody thing for me.
I mean, it wasn't an al-cheap-o machine, I think it cost me around $1700 + $38 odd for each of the extra blades. So I would really like to start using it as it is meant to be used.
Thank you in anticipation.