Need an ultra thin spanner for Carbatec Table Saw
I have a dado stack stuck in my Carbatec TSC 10HB table saw. When I bought it second hand about 8 years ago, it never came with the thin spanner used to engage the two flats on the other side of the blade shaft. Carbatec told me the next shipment of spanners would come in late September.
I think, but can't be sure, that I need a 28mm thin spanner to engage the flats. This I can buy as part of a set on EBay but only if I know it'll fit.
Can anyone tell me the exact size of the spanner? Or better still, allow me to borrow it so I can change back to a single blade?
mick