Just returned to woodwork, new to Table Routing.
I am stuck on true Dovetailing on one of these.
Can't stretch to an expensive jig that will seldomly be used.
I've watched a few videos on YouTube etc. but still puzzled. :?
Can anyone advise me about:
- The need for different Pin and Tail bits? I've seen videos where this is the case but my bit sets only have one dovetail bit of each size.
- A home made Jig/Sled that I can construct from scratch?
- I don't mind cutting Pins/Tails one by one and am happy to make it project specific if need be.
Any help gratefully anticipated.