Hi all, I've had a couple of ring holders laying about for a few years that I originally bought on ebay. I dont use these type anymore and wanted them gone. So decided to make a couple of boxes for them. I seen this idea somewhere on youtube, making a lid insert from offcuts. Involves a lot of glueing and clamping, but the end result is very effective. For the hinges I used a 6mm brass tube with a 3mm brass rod inside it. I made the box before I installed the hinges. There is a small .5mm brass washer there also , used as a spacer. All sides and lid are 11mm thick. The boxes are made from Spotted Gum and Queensland Maple (two boxes). Paul (my enter key and backspace key don't work, I've ordered a new keypad for my laptop, all I need to do when it arrives is work out how to install it)…...