Originally Posted by All thumbs
Hi all
Have enjoyed/been thoroughly confused by all the discussion on the forum on the pros and cons of the WC2000, and have decided the only solution might be to get one and give it a go.
A quick question - would really appreciate any help / suggestions.
I gather the crosscut mode capacity is limited to 450 mm or thereabouts, unless you remove the backboard spacers (ok, not its proper name, but I'm new, ok), after which you can also plunge, to get the capacity up to 700mm.
Can anyone tell me what the maximum width of material you can fit between the rear of the table and the saw is, with the back board spacers removed and the saw in the "down" position - i.e. without having to resort to plunging.
Doesn't matter if the saw won't cut all the way to the back - I'm just looking at cutting slots in some MDF sheet, and don't have a SCMS. Will a 600 mm sheet fit in without plunging ?