Dmt diamond plates discoloured after one use

Hi all

I bought a couple of dmt diamond plates recently and after one use they have discoloured quite alot (rusty colour). Is this typical? And are there are recommendations of how to clean these up?

Soap and water should clean them up.

Make sure they are rinsed with clean water after use to clear off any steel particles from the sharpening process and allow them to dry fully before putting them away. I've never had a spot of rust on mine after many years and I only ever use water, both for cleaning and sharpening.

I always clean my plates with Ajax and stiff plastic brush after every use if you leave sworf on they look rusty. Also use winded as a cutting fluid evaps faster but better cut with them.
Peter

Bar keepers friend.

As the others have said clean and dry them after use. I use cheap window wash spray when sharpening. After use they get another good squirt and wiped off with paper towel.
The stain will not affect performance and should fade away over time if you clean them every tine you use them.
Regards
John

Thanks all for the tips. Much appreciated

I use turps as a cutting fluid on the eze lap stones. Everything stays clean and turps flashes off slow enough so it's not an issue. My oldest one is 20+ years now and it still gets very regular use. The only time I ever got rust on mine was when using water. Had I cleaned the stone after use, I doubt any rust would have formed.