Redneck Rally

I was asked to make 2 of these for prizes for the Riverina Redneck Rally I have finished one but still painting the second one. I stack cut these & used 3mm ply with a 6mm MDF backing. The blades used were No 1 & 2/0 FD silver reverse. It is 17.5 inches wide, I think the painting etc took longer than the cutting but I am quite happy as to how it turned out. Must get back & finish the second one before I knock over & lose all the small parts. The one with the 2020 date is the transfer I used as the pattern.


Attachment 481369Attachment 481370

There very impressive.

Cheers Matt.

I like lots. Stack cutting is the way to go and turns out to be the quickest of the whole job then comes the painting and this is always challenging, but you have done these prizes proud.

They’ve come up a treat Peter.
Nice done sir.
Cheers Peter