Spalted Peach - How to proceed?
Hi All,
I have just sliced up a small branch of Peach, that was sitting outside for some time, and it is heavily spalted.
The useable dimensions are quite small at ~70mm x 300mm x 8mm thick. It lends itself to a lid insert, if I can glue up some slices into a panel. Probably using Titebond 3.
The question is, how should I proceed?
Should I trim and glue the slices together, and then try to stabilise the punky wood (I don’t have access to a chamber/pump etc) with a two part marine epoxy or similar. Or do the reverse?
Any advice appreciated.
George