-
G'day from Rokeby!
Hi Peoples!
Rokeby is the place to be, West Gippsland, Victoria. I run a small shop, building a variety of timber and panelled items and create stave kit drums here too. I've come along to ask a question concerning power feeds for table saws. I'd like to know if anyone has seen or built a power feeder that automatically reverses after it finishes its' cut... weird hey? But that is what I spend hours doing. I'm not getting any younger and my shoulder kills me at night from doing it. I refuse to give up though!!
-
-
G'Day & Welcome to a top forum "Roger"....
There are a good few member in the Gippsland area, a stack members around Melbourne and cross Victoria plus the rest of the country.....
You'll find a heap of helpful & knowledgeable blokes & ladies on the forum and for most very willing to assist.
Make sure you show off your handiwork as everyone loves a photo, especially WIP [Work In Progress] photos with build notes.
Enjoy the forum.
Enjoy your woodwork.....
Cheers crowie
PS - Maybe on your power feeder question you add a new thread in the general section to gain a wider audience and thus possible answers, cheers....
-
Welcome to the forum Roger.
-
-
Big Howdy Roger
Welcome to a great forum
Mr Fiddleback :roll: