WDS-4080P Carbatec wide drum sander drum motor replacement
As the title describes. I am looking to replace the drum motor.
My WDS was inherited from my late FIL. To say it has had an uncomfortable life is an understatement.
Anyway, symptoms are
Doesn't always make it up to speed, the centripital switch doesn't cut out. Have to quickly turn it off/on several times to get it onto run.
Thermal cutout button pops after a short time, minutes, even under very light load.
The small motor driving the platen mat is fine, no worries.
So I'm thinking to replace the drum motor. I have details of power speed poles etc. But where to look and what to describe it. Flange mount???
Cannot see any part numbers.
Carbatec???
Thanks for any help, direction.
Lyle
PS sparky coming mid next week to safely check it out.
Just doing some pre-emptive searching.