3D printer enclosure DIY double glazing?
Hi all, I had no idea where to post this one, but hopefully this will do.
I was thinking of building an enclosure using 2020 extrusion and 2mm (possibly 1.5) polycarbonate.
Was thinking of using 2 sheets of PC with a spacer, possibly insulating foam tape, to sit in the slot of the 2020
to act as double glazing.
Does anyone have an idea whether this might be effective?
The enclosure will be 520w x 600d x 600h so would probably do a centre brace for the top.
Any advice is appreciated
Craig