In a recent post I described an edgebander I had bought on Ebay. It's a monster and I just managed to get it into my shed and near the wiring on this past weekend.
Now I'm confused about the wiring. There's an obvious three phase line, to which I attached a plug and successfully ran the glue pot heaters and then the conveyer belt.
But there is another set of wires that I believe belong to the phase converter. This converter then runs the high frequency trimmers.
7 wires in a large soft plastic conduit (best I can do) emerge from the edgebander, and I don't know how to wire them. There are six black wires in two seperate bundles numbered 1,2,3, and 1,2,3, and an earth. Does anyone have experience with this?