Search:
Type: Posts; User: vdotmatrix
Search: Search took 0.00 seconds.
-
4th October 2015, 08:30 PM
Thread: box joint a little loose
by vdotmatrix- Replies
- 5
- Views
- 4,215
Kiss calibration is done once and you don't have...
Kiss calibration is done once and you don't have to think about this again. You should watch the video on the I-Box at the 3:45 mark: https://www.youtube.com/watch?v=3QESurntvaE
... -
27th September 2015, 04:28 PM
Thread: box joint a little loose
by vdotmatrix- Replies
- 5
- Views
- 4,215
If one needs to tighten a finger joint do you use...
If one needs to tighten a finger joint do you use the silver know to do this as described below?
Does anyone have any ideas as to what went wrong?
CUSTOMER SERVICE FAILED TO INCLUDE IN THE... -
26th September 2015, 04:20 AM
Thread: box joint a little loose
by vdotmatrix- Replies
- 5
- Views
- 4,215
box joint a little loose
I just had a disaster in the workshop. I tried to tighten up the joint by following the instructions in red. The result is a another finger about 1/8" and a gap between each joint. I thought the...
-
4th December 2014, 04:21 AM
- Replies
- 5
- Views
- 8,346
Thank you have led me to the path of...
Thank you have led me to the path of enlightenment!!!! Thank you!!!
-
4th December 2014, 04:13 AM
- Replies
- 5
- Views
- 8,346
11/16ths goes into 9.625 exactly 14 times..... ...
11/16ths goes into 9.625 exactly 14 times.....
YEAH...
thanks -
4th December 2014, 03:41 AM
- Replies
- 5
- Views
- 8,346
13/16th" is just the MAX width I can use a dado...
13/16th" is just the MAX width I can use a dado on my table saw, and it doesn't have to be 13/16th of an inch but this is the max.
So what you are saying is not to wrap my head around imperial... -
4th December 2014, 01:28 AM
- Replies
- 5
- Views
- 8,346
Ibox finger joints that begin mid board? TIPS or suggestions?
333250
I am essentially making a box with legs.
I can use a 13/16" dado ( freud ). The end piece is 9 5/8" . If I could figure out what size finger joints would work perfectly I could start the... -
30th March 2014, 03:23 AM
Thread: INCRA I-box Setup Question
by vdotmatrix- Replies
- 2
- Views
- 1,904
INCRA I-box Setup Question
I am setting up my new Ibox. The instructions say to position the red knob on the left for a left tilting saws and on the right for a right tilting saw.
Carftsman 10" jobsite table saw.
When I...