Search:

Hi Glenn, thanks for this post. I've recently acquired a Woodfast 6" jointer. Mine is also not co-planer. So I'll either need to shim it up or pull it out and clean the dovetail ways as you have...

Thanks Graeme. Are you talking about using a normal clear epoxy resin or something like Boatcraft Epoxy-E-Glue?

Thanks Me Brush. So what is the general guidelines for clamping pressure with epoxy? Also when you were talking about industrial grade epoxy, do you have any recommendations on brands?

Thanks Mr Brush. Given that polyurethane foams when it cures. I assume that you would see a pale coloured glue line when doing a lamination.

It sounds like you have a good reason to break out the Parf Guide now. Thanks for the recommendation. I’ve been eyeing off the Parf guide for a while. I’ll have to put one on my Christmas list.

Hi woodPixel, did you buy a UJK Parf Guide?

Thanks Mr Brush,

What are the advantages of polyurethane over epoxy?

Hi Sleake,

How did you go with this? I've got a similar project coming up. The temptation is to reach for the Titebond III. However like you, I've got concerns that it is the right product for...

I might regret taking on such a project. However I'll take it:) I'll PM my number to you.

Hi Greggyboy,

Would you take $180 for it.

Hi Barri. Do you know if the Freud SD508 is available in Aus to suit a 30mm arbor? This is one of the one's that I have been looking for.

Thanks Gents. I must admit that I had planned on going the Swiss cheese approach. However I completely take your point about small objects falling through. I'll have to rethink the dog hole layout.

I recently bought a Torquata Metric Dado set from Timbecon. However I found that the tolerances on the bore were a bit too tight on my 30mm arbor. So ti was difficult to get on and off. The end...

I am about to embark on building a new work bench. I just wanted to get some feedback on the best dog hole size to run with? Specifically I am talking about 19mm vs 20mm. Obviously there are a...

Hi Austin,

I sent you a PM earlier with my personal details.

Many thanks.