Search:

That would be a great help thanks.
[email protected]
0401684542

Chris, I would have used it at least every few months at worst. I fiddled around today connecting an el cheapie variable voltage unit to VFD. A couple of times the VFD sprang to life at about 50v...

Both were sourced in Australia. I bought the first about 10?? years ago & it just stopped working after about 6??? years. I did a bit of box making in those days but it did not get a lot of work. I...

I have a PI500 004G1 VFD which shows nothing at all on the display. It did show an error code but I didn’t write that down. Error code showed for a few days , then blank screen.
There is 240v power...

Hi Lappa,
That looks exactly like what I am after. I will try some of the appliance places in Toowoomba when I am in town next.

421620

I have a small piece of 100mm suction hose as shown which will concertina together & stay there & also bend into various curves & stay there.

Only one problem. I have no idea how, where...

Thanks everyone for the advice. I will just use normal cable & if there is a problem later, then I can fix it.

In the "Guide to using a Powtran" page on the Clearvue Aus website it states "It is preferable to use a shielded cable for this linkto avoid any radio interference."
How important is this given that...

Thanks BobL. That is just the clarification I was looking for.

I have a Powtran PI8100a 004G1 VFD which is to be connected to a 15 amp single phase supply & then this will run a 3 phase 3kw Monarch Induction motor from Teco Aust on my Dust collector. The plate...

I am making two slab tables for a friend. The inside table will have steel frame legs & the outside one will have timber legs. I have the following queries.

1. Can U beauts Hard Shellac be used...

A friend has felled a large Blackbutt tree from his block & wants me to make up an dining table & outdoor table from slabs from this tree. The timber has been stored under cover for several years &...

I made a Huon Pine box about 18 months ago & have had it on a bedside table since then, not in direct sun. The nice light Huon colour is darkening. I cannot recall what I used to finish this...

I will be in Melbourne between 4th & 7th of Sept while SWMBO attends a conference. Does anyone have any suggestions of some woodwork premises/galleries which might be worth a visit? My particular...

This is a tree native to SE Qld dry rainforest/scrub areas. I saw this one near Dayboro last weekend. It was approx. 25m tall with base dia of 700mm. I last saw the timber in the Lockyer valley...

Thanks John, I will investigate ammonia fuming as well.

Thanks Bob. I assume you mean ordinary caustic soda (drain cleaner)?

I am making a mailbox out of old hardwood fence palings. It will be a miniature house<!-- google_ad_section_end --> which will hopefully look something like the one pictured. As I am always in a...

I am laminating Bloodwood (Corymbia gummifera) boards to make a workbench. Boards are 1800 long 95 deep & 45 wide. They have been rough cut & stickered for 10 years so are really dry. I have...

I have been bitten by the box bug & now I need to find a supplier in the Brisbane/South Qld area for 6mm venered ply for the box bases. Preferably with a Red Gum veneer or something similar on one...

Can anyone advise where I might source solid brass continuous piano hinge in Australia. I need an opened width of about 16mm for box making. So far I have trolled through nine internet sites to no...