Search:

sold

WA, i have a 2 speed 3 phase motor and contactors/fuses etc.
5 hp 2 pole
3 hp 4 pole

$75 ono

438098
438099

Bob, I think with a few year old sample, and both being hygroscopic the density difference wont help to distinguish them.

Bob, when I am off holidays and back at work we can use the photon ux100 and actually measure it, we are good for up to 800,000 fps.

I believe 1 round was going to be taken from the base of the log to send to the university for dating. The rest of the log I haven't heard anymore about.

I hope they stay open, great to have some other choices. I have personally spent over $8,000 with them since they opened here in WA.

Also what meter are you using to measure the voltage? A lot of digital meters don't add any load and you can read an induced voltage in those lines.

Sam, private message me your email address and I will send you the manual for the saw. You do not need to undo the top to remove the blade.
Ben

That is an ASEA 3 phase motor, details of motor will be on the fan cover end.

Now that we have seen the motor terminal box, you will have to do as Bob suggests,
if you want full motor hp either dig out the star point or take it to a motor rewinder to do it for you.
If you...

That is the main switch not the motor terminals. You need to see where the wires from that switch go too. It should then have other terminals you can connect to.
You do not want to connect the vfd...

If i am going to keep the fuel for more than a week i try to get premium, 95 octane. The problem is a lot of fuel stations now only stock normal 91 and 98.
I have found that the 98 burns to slowly...

Without any back

I take it the tank was empty. Is the compressor valve noise due to no backpressure on the system? run it for longer and see if it continues

Any recommendations for steel door frames instead of wood?

I am in too
97777777

Great saw. Friend has one and it cuts alongside my 372xpxt. Not quite as fast but we have never had a problem with the 60cc Makita.

Thanks for the pointers, it is now up and running at full power. Now to make It do some work and decide if it needs more.
I was a combination of program settings and wiring.

Ben

Here are the nameplate and wiring connections.
341578341579

I have tried the reset and another motor. But thanks

I have a CMG 3 phase motor 240v Delta, 415v star. Connected to a teco/Westinghouse FM50 drive, Single phase input to 3 phase output.
The problem is when connected in delta the motor hardly turns(set...

You are looking for a Haskel pump (brand name) or similair to transfer gas between cyclinders with out contaminating it. These all cost quite a few $, I have one but it would be over $6k to replace....

Not sure if i really should thank you again or not Bob, I now have a 3120 on the way...

Cheers Bob and Gavin for a good day out, sorry I had to leave before the beers. Was a very informative day, now time for me to set up some gear and see what i can do.

Cow, I would like to attend to see BobL in action! I am in the same boat, would like to start milling but need some help.