Search:

awesome info, thanks

thanks for the response, shelf will be in th lounge room, more of a mantle than a shelf, I guess. Epoxy resin is an option but not top of the list

Hi Everyone.

I am making a shelf out of, (what I believe) is ironbark. While milling the slab, I have noticed this wood splinters really easily.

With this in mind, I am looking for suggestions...

Hi Everyone.

I have got a few pieces of timber available, which I would like to have milled into 25mm thick slabs.

They vary in length from 750mm to 130mm and width from about 150 to 300mm...

thanks, sounds like a plan.

Hello All

I have a TPT 13 thicknesser and managed to bend the gib recently.

Does anyone have any ideas on where to get one.

I have searched online but have not had much success.

Tool...

thanks for the replies,

Hello all.

A mate of mine is having a tree felled and has offered it to me, if I can get it cut.

it is about 60cm in diameter, height, he reckons 35 m.

is it worth getting it milled, I am...

thanks Jazzy, will do

Haven't thought too much about that one, the project is for a relative of mine and money is rather tight.

Hello all

I am looking to buy a couple of timber slabs to make an outdoor benchtop for a BBQ area, I would probably need to join two slabs together, as the top is planned at about 900mm wide. In...

still available?

thanks,

thanks for the offer, I'll see what I can do, I'd prefer not to rip them to 200mm or less. I understand the reality may be to have to do so but let's see what happens

Hello All

I have a 14 old stair treads, which I would like to resaw to recycle the wood.

The steps are 260mm x 40mmx 850mm, my bandsaw is too small to accomodate the 260mm height.

Any idea...

thanks for the advice. I can't remember if I did allow the bit to bottom out or not but will give it a go with the 4mm gap.

Cheers

Hello all.

I have a Triton router and recently used a 2" flush trim router bit (1/2" shank) for the first time.

I was trimming 17mm plywood with it. The bit kept on coming loose after routing...

Thanks PKER

I found a company in West End, Peacock Saws, they did a great job for me. They were also able to make up bandsaw blades for my 72" bandsaw. I'll have a chat to your guys too.

Hello all

I am looking to get a set of jointer blades (4") sharpened. I live northside of Brisbane. Can anyone recommend someone in this area to do the job.

Thanks

thanks for your replies.

it seemed like a good idea at the time but makes sense now to give it a miss

I some plywood which was coated on the one side with bitumen. Is it easy to remove, if so, safe and affordable?