Search:

Only about 15-20mm spring that was pulled in and screwed by the shelf.
in hind sight, i could have added a layer of ply over the shelf screw holes, but they are not that visible as is.
Used regular...

Completed table.
Not perfect, but happy with end result.

I tried a few test runs with a sliding dovetail joint, but was not confident enough to have a go on the table.
So at this stage, i have decided to have a shorter section of tasie oak (65/19)screwed...

It is looking like i will give your suggestion of adovetail joint a go.
Can i assume, as with the link you posted about the join, being ply or laminated ply will not be any different to using normal...

Once the glue has dried, i was planning to trim and sand the length, and all edges to size.

Thinking it may be more hassle to add a shelf.
Do you think 8 x 3mm layers would allow the uprights to...

That sounds great, but far to advanced for my skill set and power tool collection i'd say.
In hind sight, maybe i should have screwed the shelf in before the last layer or two of ply on top.
Is...

The attached photo is of the table still clamped,, as it was only glued up today.
if i do need a mechanical support, i suppose on the underside of the shelf would be the best spot, and in from the...

I have had a go at making a small table by laminating ply in a large U shape basically. U upsidedown that is.Once the glue dries, i want to router out a 12mm wide x 9mm deep (3x3mm plywood layers)...

I have some 42/19 Merbau timber left over from a screen i built, and i want to use it to make a couple of simple rectangular frames(possible cross brace) to stiffen.

I have 2 french timber doors...

Hi guy's.
I am looking at fitting some Stack Stone to a corner internal wall.
I am only having it approx 1000mm high by 1200mm wide behind a slow combustion fire being installed.

My old drop saw...