Search:

Thanks everyone

I’ve been building melanin cabinets for my pantry and it is very accurate. I have cut a few hardwood pieces and found it accurate and powerful enough.

Yes I bought one about 4 months ago and so far I am quite impressed. Pretty straightforward to set up and true everything. I’m no specialist woodworker but I’ve got no complaints.

I am building some shelving for my walk in pantry. I had to remove the existing skirting board which has left a gap of 20mm wide and 12-15mm deep between the floor tiles and the gyprock wall. I’m...

I am building some shelving for my walk in pantry. I had to remove the existing skirting board which has left a gap of 20mm wide and 12-15mm deep between the floor tiles and the gyprock wall. I’m...

That’s the one. Thank you very much. Will order today.

I have been using this circular saw on my triton workcentre for a few years. I now have removed the saw as I have a new tablesaw.
The blade guard on the circular saw has lost its tension in the...

Ok. I’ll keep an eye on that. Thanks for that.

Hi there it’s at Bunnings for $120.
Ryobi 20L Stainless Steel Wet Dry Workshop Vacuum

Thanks for reply.

I managed to buy a guard support from Chris. All fixed now. Thank you for your help.

Hi there. I want to set up my ryobi vac to a dust deputy cyclone.
The vacuum pipe from the ryobi vac attaches to the port at the top of the dust deputy.
Then I attach another vac pipe to the port...

Sorry David. Have not been on this site for a while. I’m still looking for the guard support without any luck. Did you have any success?

Hi. I broke the overhead blade guard on my triton 2000 and on the lookout for a replacement. Anyone out got one for sale?

Ahh I see. Thanks rwbuild

Thanks Springwater.
Will be doing some reading tonight.

Thanks Aldav

Hi rwbuild.
Thanks for your reply.
I am wondering how you arrived at a rise of 213 and a run at 345.
The treads 116 x 45 so I thought I would lay 2 treads with a 20mm gap in between and a 20mm...

Hi Ian
Thanks for your reply.
Yes I did measure the rise at the bottom stair landing point as you suggest.

I’m in

Hi all
I am about to start building some stairs outside.
I have purchased the timber. I am using 280 x 45 treated pine for the stringers.
I have been looking online at calculators to assist in...

Hi all.
I spent this morning cleaning up an old Ryobi CMS812 210mm compound mitre saw in order to give it a tune up. Was coming apart nicely and lots of sawdust and gunk was removed.
However, I...

Hi all
I have a mK3 triton tablesaw and I like it a lot but would like it a whole lot more if I could cut about 500-700mm wider than the table allows.
Any plans for a shop made type extension table...

Has anyone out there got any tips on making timber angle brackets out of scrap that I can fix to a brick wall to hold a cupboard that I want to keep raised off the ground. The dimensions of the...