Search:

I'm less interested in the 150mm but if there aren't any takers for the 125mm it could be a decent fallback.

The 150mm are priced per the below table. 180+ grit isn't in stock, so I've gone for...

Hi Forum,

I want to give the 3M Xtract II Net Disc's a go. A sandpaper roundup/review indicated they're decent quality and even though a little expensive per disc, represent good value for money...

The motor on my old 14" bandsaw burnt out yesterday tripping the safety switch and making some interesting smells.
Its an old WA-14M which I got off an old chap who was retiring.
496034
Now I'm...

Is it this one?496026
I've scrounged up this scanned manual which is mostly legible.
CII WA-14M Band saw.pdf - Google Drive.
Mine has a label on it saying it was sold from Gregory Machinery....

I agree the choking is likely due to the depth and tpi but I still feel like the hardwooods that I’m going to be putting through will inevitably eat up the bimetal blades.

From reports the TCT...

I jam a 1hp 10cm dust collector hose against the gap at the bottom of the bandsaw and hope for the best :unsure:.... So it could definitely be better.

The bandsaw is an old WA-14m and there...

Some further pics showing the build up on the current bimetal blade and the wheel width.

I don’t think I’ll be able to have a one inch blade on there now that I’ve checked and measured. 1” is...

Thanks. I figured the TCT would be next best step but it’s good to have confirmation.
Cheers!

I scored a 14” bandsaw from a neighbour of a mate who was downsizing. It’s been a bit of a cash trap as it’s been breaking on me in various ways since I got it (snapped both trunions when I first...

No good gentleman.

I'm now doing more harm than good.

https://picasaweb.google.com/lh/photo/B0CardPX6WOeqCdZBHVWftMTjNZETYmyPJy0liipFm0

The vice grips started to cut into the spindle and...

Well I tried to use a bolt as a pin through the drive shaft.
It bent :). Was lucky to get the famed thing out.
Pics here. ...

Hi Cliff. Thanks for the suggestion.

There is a small part of shaft that is threadless that i may be able to clamp onto but its only 10mm wide so its not much surface area to grip. I've got to...

I've tried the following.


Hammer on insertable handle
First I'd tried my usual method of simply putting the insertable handle into the adapter ring, holding the gear wheel by hand and tapping...

Hi to the forum's. I've got a problem that I'd really appreciate some help with.
I've got an Elu DB180 woodlathe that I picked up second hand 12 years ago. Its not a fancy bit of kit but it does the...