Search:

Another idea is that the material that manufacturers use for their die stock maybe 25mm dia nominal so no outside dimensions are machined/ground.
Borriss

Hi Jacqualos,
A method I have used for years to set the mesh of the change gears is to insert a piece of paper between the gears when pushing them into mesh. After the stud is tight roll the spindle...

Hi Timeless,
One reason I have found for hydraulic jacks leaking is the screw in the base for lowering the jack. This is usually a 3/8 UNFbolt (or M10) with the end flattened for the jack handle....

Hi Uee,
I would suggest you harden and temper/case harden the ratchet gear because on my Douglas the pecker is hardened and it is wearing away the gear wheel. Douglas does get used a lot though....

Hi Guys,
If in doubt follow the manufacturers instructions for the Clarkson. The cutters self tighten and will not pull out. During my apprenticeship I saw a clown leave the nut unscrewed about half...