Search:

I'm in

All there now

Thanks for your reply Phil.

I also purchased a TOS surface grinder at the same time (package deal) and it takes a 10" (250mm) wheel and has a 3" (76mm) bore.

The wheel on the repco-power...

Hi Mark,

Did you end up locating a manual for your machine? I recently acquired an S6 myself without a manual.

If you or anybody else has a copy it would be appreciated.

I'm also interested...

$150 negotiable I think

Hi Stinger,

Here is a picture of how mine was installed. You can see where it was redrilled. It is also press fit.

Hi Stinger,

I was faced with the same issue as you.

The shaft was pressed in and had two hex grub screws. They were drilled and tapped half in the shaft and half in the top slide to prevent it...

That's what I thought in both need and space. Fortunately I'm using some warehouse space at work, and the need......well it was a Gumtree find and couldn't say no and it was local. I will send you a...

Hi Bob,

Thank you for the pictures and information, it is appreciated.

There are some differences between the 9 and 9A but they are similar machines. I can see some of the linkages are the same...

Hi Pete,

No problem. I plan to put up some pictures and any other relevant information I find. I'm sure there are others out there somewhere.

Thanks

Hi All,

I recently acquired a Hercus 9 cylindrical grinder and in the process of giving it a good clean and semi-restoration.

Unfortunately I have found very little information on this machine...

Had a look today. There are two Mazak lathes. One has a very long bed.

They look ok given the conditions there. Some pictures for you.....

321872321873321874321875321876321877321878321879