Search:

Type: Posts; User: russ57

Page 1 of 10 1 2 3 4

Search: Search took 0.02 seconds; generated 42 minute(s) ago.

  1. Thread: My shed leaks

    by russ57
    Replies
    20
    Views
    427

    Thanks aldav.

    Thanks aldav.
  2. Thread: My shed leaks

    by russ57
    Replies
    20
    Views
    427

    Thanks but that just links to a general page-no...

    Thanks but that just links to a general page-no product...
  3. Thread: My shed leaks

    by russ57
    Replies
    20
    Views
    427

    Something like this Consolidated Alloys 150 x...

    Something like this
    Consolidated Alloys 150 x 0.7mm x 10m Weatherflash | Bunnings Warehouse

    Or adhesive version Consolidated Alloys 100mm x 10m Weatherproof Byute Flash Flashing Tape
    If I can...
  4. Thread: My shed leaks

    by russ57
    Replies
    20
    Views
    427

    Thanks Bob I did the upturns well after...

    Thanks Bob
    I did the upturns well after installation, they got "missed" during the the original install.
    Ive always wondered would those in fills just hold water and end up rusting out the sheets....
  5. Thread: My shed leaks

    by russ57
    Replies
    20
    Views
    427

    Thanks for everyone's comments. I cleaned the...

    Thanks for everyone's comments.
    I cleaned the leaf litter today. The area of the leak had a little build up but not as bad as I feared. There are a few trees which will be getting the chop, was...
  6. Thread: My shed leaks

    by russ57
    Replies
    20
    Views
    427

    My shed leaks

    Well, actually it's the verandah.

    Shed and verandah roof are trimdek. The verandah roof (pretty flat) is tucked under the shed roof (steep). Water drips from the overlap. The ends of the sheets...
  7. Replies
    1,146
    Views
    24,624

    Sticky: Royal wave

    Royal wave
  8. Replies
    7
    Views
    1,166

    The original poster hasn't been seen since (or...

    The original poster hasn't been seen since (or before for that matter) the original post in February.
  9. Sounds like a great adventure :yippee: Hope it...

    Sounds like a great adventure :yippee:
    Hope it works out really well for you both. Have fun...
  10. Replies
    1,146
    Views
    24,624

    Sticky: Pong

    Pong
  11. Well, to get 50x50 from your bench top, you need...

    Well, to get 50x50 from your bench top, you need to cut 2 pieces 660 x50x25, and laminate those into a 50x50. I gather you need 6 legs. So 12 pieces. You won't get that from a single width of the...
  12. Replies
    2
    Views
    162

    Well...... Firstly, the finished product looks...

    Well......
    Firstly, the finished product looks OK.
    But it is definitely not a restoration, not in my view. Maybe a 'reconstruction' would be a better description.
    Also, better lighting would...
  13. What about suppliers such as Matthews or...

    What about suppliers such as Matthews or hazlewood and Hill. Better range than bunnies.

    Are your rubberwood tops long lengths or finger jointed shorts?
    But a little reading suggests rubberwood...
  14. Replies
    1,146
    Views
    24,624

    Sticky: Splutter

    Splutter
  15. Thread: Hinges

    by russ57
    Replies
    2
    Views
    181

    What sort of doors? I think that standard kitchen...

    What sort of doors? I think that standard kitchen cabinet type overlay hinges could work. You'd need to put a packer/filler inside the face frame so the hinges are flush. There is a choice of...
  16. Replies
    1,146
    Views
    24,624

    Sticky: Lounge

    Lounge
  17. Yeah, looks like it needs more sanding, perhaps...

    Yeah, looks like it needs more sanding, perhaps even down to 180. Is the wood completely dry?
  18. Replies
    1,146
    Views
    24,624

    Sticky: Ozzie and Harriette

    Ozzie and Harriette
  19. Replies
    1,146
    Views
    24,624

    Sticky: Queen's angry

    Queen's angry
  20. Replies
    1,146
    Views
    24,624

    Sticky: W C Fields

    W C Fields
  21. Replies
    7
    Views
    285

    1. Research. 2. Check the price against local...

    1. Research.
    2. Check the price against local online and physical.
    3.Don't forget currency conversion and gst.
    4. Be prepared for a long wait.

    Personally, I look for at least 20-30% saving. ...
  22. Replies
    29
    Views
    967

    I found Pipe Online - Retic Fittings , Plumbing...

    I found Pipe Online - Retic Fittings , Plumbing Fittings, Reticulation Supplies supplied Australia wide was cheapest, assuming you need just fittings even with shipping.
    They could arrange pipe as...
  23. Replies
    1,146
    Views
    24,624

    Sticky: Expletive deleted

    Expletive deleted
  24. Replies
    3
    Views
    369

    And the colonel's new driver Mary.. Still...

    And the colonel's new driver Mary..

    Still good...
  25. Replies
    1,146
    Views
    24,624

    Sticky: Unreal

    Unreal
  26. Replies
    1,146
    Views
    24,624

    Sticky: Ram

    Ram
  27. Replies
    2
    Views
    343

    I'd probably be trying to remove with paint...

    I'd probably be trying to remove with paint stripper to start, then maybe sand.
    Contact taubmans tech for advice on what stripper could be best.

    I'm assuming that you are talking about the...
  28. Replies
    18
    Views
    586

    Vinegar for mould, not bleach...

    Vinegar for mould, not bleach...
  29. Replies
    6
    Views
    450

    I don't suppose you know what the original stain...

    I don't suppose you know what the original stain was?
  30. What about through tenons with wedges? Easy to...

    What about through tenons with wedges? Easy to knock down and keep tight..
  31. Replies
    1,146
    Views
    24,624

    Sticky: Stain

    Stain
  32. Replies
    1,146
    Views
    24,624

    Sticky: News from the front

    News from the front
  33. Replies
    1,146
    Views
    24,624

    Sticky: Redhead

    Redhead
  34. Replies
    1,146
    Views
    24,624

    Sticky: Roast lamb

    Roast lamb
  35. Replies
    7
    Views
    327

    Not a lot to a grinder I guess. Assuming the...

    Not a lot to a grinder I guess. Assuming the bearings are OK, a quick paint job and it will be like a new one!
  36. Replies
    7
    Views
    327

    A restoration project! Hopefully the price is...

    A restoration project!

    Hopefully the price is right... At the very least, new wiring. Looks like rubber cable which may very well have perished.
  37. Replies
    1,146
    Views
    24,624

    Sticky: Pet

    Pet
  38. Thread: Cordless Drill

    by russ57
    Replies
    1
    Views
    274

    .. :wink:..

    .. :wink:..
  39. Replies
    15
    Views
    898

    I read the council form thus: If the -'design...

    I read the council form thus:

    If the -'design and specifications for the fireplace include your details then an application is not required. Ie, the design and spec is individual to your...
  40. Thread: Just Groans

    by russ57
    Replies
    14
    Views
    451

    Beer bottle - Wikipedia...

    Beer bottle - Wikipedia
  41. Replies
    1,146
    Views
    24,624

    Sticky: I was busy

    I was busy
  42. Replies
    1,146
    Views
    24,624

    Sticky: Amateur teacher

    Amateur teacher
  43. Replies
    1,146
    Views
    24,624

    Sticky: Isolation

    Isolation
  44. Replies
    1,146
    Views
    24,624

    Sticky: Gang Show -russ

    Gang Show

    -russ
  45. Replies
    1,146
    Views
    24,624

    Sticky: San serif

    San serif
  46. If it's that new, I'd be taking it back if there...

    If it's that new, I'd be taking it back if there is any doubt.one of the benefits of buying local retail is good warranty service.
  47. Check with a magnet. Could be plated steel. The...

    Check with a magnet. Could be plated steel.
    The little patch on the inside knob looks like it could be bare steel.
    Also the two tone dress ring suggests plating.
  48. Replies
    7
    Views
    681

    An ssd for the system drive, even only 256g, will...

    An ssd for the system drive, even only 256g, will make an <enormous > difference, in booting and opening programs.
  49. Thread: Another re-roof

    by russ57
    Replies
    7
    Views
    410

    Leaking mainly around a skylight, but rust in...

    Leaking mainly around a skylight, but rust in lots of spots.
    About 10 years ago (?) had it cleaned, rust treated and sealed with an insulation paint.
    That worked pretty well but the rust is showing...
  50. Replies
    8
    Views
    642

    Yep, looks like chipboard to me.

    Yep, looks like chipboard to me.
Results 1 to 50 of 487
Page 1 of 10 1 2 3 4