Thanks: 0
Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 4 of 4
Thread: Veneered plywood
-
28th July 2009, 01:06 PM #1Member
- Join Date
- Jun 2006
- Location
- Perth, Australia
- Posts
- 74
Veneered plywood
I've a got a small project making a clock and the instructions call for the backing to the cabinet to be 6mm plywood veneered with the wood being used for the project. I'm considering using Jarrah or Red Cedar.
The backing is to be in 2 parts, approx 30cm X 30cm and 45cm X 30cm.
I have the use of a 19" bandsaw. I was wondering would it be possible to resaw the Jarrah or Red Cedar to as thin as cut as possible and glue this to the ply? or should I find a company that can supply veneered ply? or use a resawn cut of 6mm thickness and not worry about the ply? I'm wondering if the latter solution may have problems with distortion later on.
-
28th July 2009 01:06 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
28th July 2009, 01:31 PM #2SENIOR MEMBER
- Join Date
- Jul 2003
- Location
- Melbourne
- Age
- 53
- Posts
- 856
A well tuned bandsaw will be able to resaw and cut the veneer you need, you will have to sand out the bandsaw blade marks. If you have access to a bandsaw with the right blade i'd say go for it.
If you need to buy blades etc you might be better off buying a pre-veneered panel or if its just the backing maybe look at getting some bunnings iron on veneer...
joez
-
28th July 2009, 02:45 PM #3Member
- Join Date
- Jun 2006
- Location
- Perth, Australia
- Posts
- 74
How thick can I leave a bandsawn cut veneer than can be fixed to the ply? Would 3mm be too thick? does it need to be paper thin? I'm confident I can resaw a veneer. The band saw is new and I have a blade suitable for resawing (1/2 " wide, 3 tpi, hook tooth).
-
28th July 2009, 03:03 PM #4
Similar Threads
-
veneered plywood
By woodie2 in forum WOODWORK - GENERALReplies: 0Last Post: 30th December 2008, 01:12 AM -
Marine Plywood vs Baltic Birch Plywood
By bateau in forum BOAT RESOURCES / PRODUCT SEARCHReplies: 7Last Post: 9th July 2008, 02:58 PM -
Veneered Ply
By bennylaird in forum WOODWORK - GENERALReplies: 11Last Post: 17th October 2005, 02:11 PM -
Veneered Plywood
By Mark Woodward in forum TIMBERReplies: 2Last Post: 22nd January 2001, 05:21 PM -
Veneered MDF
By Iain in forum TIMBERReplies: 2Last Post: 30th December 2000, 09:24 PM