Likes: 0
Needs Pictures: 0
Picture(s) thanks: 0
Results 1 to 5 of 5
-
9th September 2015, 11:14 PM #1New Member
- Join Date
- Sep 2015
- Location
- Australia
- Posts
- 3
Wood fast lathe...step pulley assembly.
Hi all, can anyone help...I have an old woodfast lathe and need to replace the head stock pulley assembly, can anyone suggest where to start.
Also I can seem to remove the spindle shaft from the head stock, any pointers...need to re do the bearings?
cheers
-
9th September 2015 11:14 PM # ADSGoogle Adsense Advertisement
- Join Date
- Always
- Location
- Advertising world
- Posts
- Many
-
10th September 2015, 08:41 AM #2
Try this link - http://images.machineryhouse.com.au/...PDF/Manual.pdf
Its for the newer M910's but will give you the basics.Mobyturns
In An Instant Your Life CanChange Forever
-
10th September 2015, 01:21 PM #3GOLD MEMBER
- Join Date
- Jan 2009
- Location
- Australia
- Posts
- 1,222
My old X150 had circlips each end of the spindle in the headstock.
Remove any chuck etc, remove drive pulley. Mine has a grub screw and the pulley came off very easily. Others might need a bearing puller of sorts.
Using circlip pliers or a sharp pointed tool take out the circlips from each end of the headstock.
Slide out the spindle shaft, mine came out towards the tailstock.
Then using a long drift gently tap out a bearing out of the headstock, then do the same for the other end. You tap them out from the inside of the headstock to the outside.
When you took them out the spindle shaft came out, but left inside a spacer.
When the bearings were gently tapped out you could see and get to the spacer.
To put new bearings in is easy.
Gently tap in a bearing, slide in the shaft from the tailstock end and put the spacer back on then gently tap in the other bearing.
Refit circlips. Test run.
Pic of my old lathe if any help.
Attachment 359160
My bearings cost about $8 each, but I just took the first I could find and didn't shop around.
Hope this may help.
-
12th September 2015, 12:16 AM #4New Member
- Join Date
- Sep 2015
- Location
- Australia
- Posts
- 3
Wood fast lathe spindle
Hi all,
can any one help, I can't seem to get my spindle to come out...I hammer it a certain length and it just stops dead and goes no more. It seems that the step pulley hits the inner casing then that's as far as it goes.
Anyone got the tricks of the trade when it comes to removing a spinal that gets stuck.
-
18th September 2015, 07:22 AM #5
Have you checked for grub screws to attach the pulley to the shaft.
Probably be 2 Allen headed.
H.Jimcracks for the rich and/or wealthy. (aka GKB '88)
Similar Threads
-
Wood fast M408S lathe manual Wynyard Community Men's Shed
By dags3777 in forum WOODTURNING - GENERALReplies: 7Last Post: 2nd December 2021, 07:36 AM -
Step cone pulley
By Optimark in forum GENERAL & SMALL MACHINERYReplies: 21Last Post: 6th September 2012, 09:17 PM -
Woodfast lathe bottom pulley
By Mr Santa in forum WOODTURNING - GENERALReplies: 11Last Post: 2nd May 2009, 12:40 PM