Search:

Tag: 73mm

Search: Search took 0.00 seconds.

  1. QLD NG rosewood

    Started by jearve, 10th May 2014 06:36 PM
    1875mm, 73mm, 95mm, guinea, piece, required, rosewood, seasoned 3 Attachment(s)
    • Replies: 0
    • Views: 1,242
    Last Post: 10th May 2014 06:36 PM
    by jearve  Go to last post

    Forum:
    Market Place/Auctions

  2. Was this just good luck?

    Started by BRADFORD, 7th December 2012 04:25 PM
    400mm, 73mm, base, bed, centre, check, chuck, easily, fix, front, good, happy, influence, jaw, lathe, luck, measurement, middle, moon, mounting, mucking, nearer, pig, previous, result, roll, section, tailstock, taper, theory
    • Replies: 10
    • Views: 1,878
    Last Post: 8th December 2012 12:52 PM
    by pipeclay  Go to last post

    Forum:
    METALWORK FORUM

  3. What Oz timbers are similar to Hickory?

    Started by Hermit, 25th August 2012 01:57 PM
    3 Pages •
    1 2 3
    1.6mm, 1/16, 15.9mm, 5/8, 7/8, 73mm, advice, ash, blackbutt, bolt, build, edit, flat, hickory, jarrah, latch, oak, padlock, plans, reckon, similar, spring, strip, successfully, tas, thick, timbers, victorian, wide, wooden
    • Replies: 44
    • Views: 10,761
    Last Post: 30th August 2012 09:07 PM
    by pmcgee  Go to last post

    Forum:
    WOODWORK - GENERAL

  4. Pulley Dimensions - For Derek

    Started by Anorak Bob, 27th March 2011 04:21 PM
    100mm, 109mm, 136mm, 33mm, 60.4mm, 71mm, 73mm, 98.4mm, arl, bitza500, bottom, countershaft, derek, diameter, dimensions, motor, o.d, pulley, pulleys, speed, vee
    • Replies: 7
    • Views: 2,025
    Last Post: 10th May 2011 10:39 PM
    by pipeclay  Go to last post

    Forum:
    THE HERCUS AREA

Results 1 to 4 of 4