Search:

Tag: concerns

Page 4 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Timber Floor over slab?

    Started by VinoTinto, 10th January 2005 07:25 AM
    addition, adequate, advance, airflow, boards, builder, circulation, comments, concerns, configuration, floor, floor/batten/concrete, lots, minimal, moisture, probs, raising, slab, stability, timber, vino
    • Replies: 8
    • Views: 2,969
    Last Post: 14th January 2005 04:31 PM
    by Gaza  Go to last post

    Forum:
    FLOORING

  2. Borers in Kauri pine floor

    Started by OL!, 16th December 2004 09:23 PM
    advise, bad, bits, boards, borer, borers, concerns, cost, damaged, fill, finished, floor, found, hey, holes, hope, house, kauri, length, matching, minutes, obvious, offered, pine, polishing, replace, size, talkative, tia, typed
    • Replies: 13
    • Views: 4,032
    Last Post: 21st December 2004 09:39 PM
    by seriph1  Go to last post

    Forum:
    FLOORING

  3. Bled'in Pine

    Started by Blackpete, 7th December 2004 11:33 AM
    20yr, bledin, concerns, cutin, dry, dust, finished, gday, harmful, norfolk, pete, pine, start
    • Replies: 9
    • Views: 2,207
    Last Post: 9th December 2004 08:29 AM
    by Blackpete  Go to last post

    Forum:
    TIMBER

  4. Burning Pine

    Started by Simple, 8th July 2003 03:59 PM
    bulk, bunnings, burning, collecting, concerns, confused, cuts, dangers/health, enlighten, fireplace, framing, green, hazards, heap, heating, home, house, inside, knots, lengths, material, pine, potential, purchase, putting, simon, timber, toys, unsure, unusable
    • Replies: 2
    • Views: 2,615
    Last Post: 8th July 2003 10:22 PM
    by journeyman Mick  Go to last post

    Forum:
    TIMBER

  5. Building a Triton Rocking Horse

    Started by Mike_R, 21st May 2003 12:59 AM
    6mm, bending, bends, brackets, building, concerns, diameter, facilitates, form, forward, gas, hearing, heat, horse, hot, l.p, metal, operation, oxy-acetylene, plan, rocking, rod, rods, sharp, solving, source, steel, successfully, torch, triton
    • Replies: 1
    • Views: 3,771
    Last Post: 21st May 2003 10:27 AM
    by DPB  Go to last post

    Forum:
    TRITON / GMC

  6. Hardened Shellac.

    Started by Dylan SJ, 21st February 2003 10:56 AM
    applying, coat, coats, concerns, days, dewaxed, dries, dylan, effect, finish, hard, harden, hardened, humidity, instructions, melbourne, muggy, planning, pretty, questions, recommend, regular, sanding, shellac, table, top, traditional, u-beaut, wax, weekend
    • Replies: 2
    • Views: 3,854
    Last Post: 24th February 2003 03:41 PM
    by Dylan SJ  Go to last post

    Forum:
    FINISHING

  7. Purchasing a Triton Workcentre

    Started by Ren, 26th November 2002 10:44 AM
    185mm, 235mm, 68mm, beginner, concerns, dedicated, depth, foldable, folded, leave, lose, markita, max, mode, noticed, postion, powersaw;, purchasing, question, ren, serious, setup, tablesaw, thinking, triton, users, woodworking, workcentre
    • Replies: 4
    • Views: 2,670
    Last Post: 26th November 2002 03:26 PM
    by Stuart  Go to last post

    Forum:
    TRITON / GMC

  8. Timber for an outdoor model bridge.

    Started by Wood Knot, 27th September 2002 01:50 PM
    affected, bridge, bridges, concerns, considered, drill, epoxy, extra, ideas, landscaping, model, nails, nice, oak, outdoor, pine, pond, protect, resin, soft, splitting, stain, strength, tap, tassy, timber, type, waterfall, wide, wood
    • Replies: 3
    • Views: 2,436
    Last Post: 30th September 2002 08:25 PM
    by soundman  Go to last post

    Forum:
    TIMBER

    • Replies: 6
    • Views: 2,397
    Last Post: 8th February 2002 03:12 PM
    by DPB  Go to last post

    Forum:
    TRITON / GMC

  9. Red Cedar

    Started by Berwickjames, 29th June 2001 05:37 PM
    advice, appreciated, cedar, concerns, health, red, wood
    • Replies: 1
    • Views: 1,524
    Last Post: 29th June 2001 07:06 PM
    by RETIRED  Go to last post

    Forum:
    TIMBER

  10. Wild Grain in carving

    Started by John Saxton, 5th April 2001 09:04 PM
    allay, assuming, attempting, carving, cheers, chisels, concerns, cut, deal, doubt, explain, fine, forum, grain, indolence, johnno, methods, neil, poser, possession, reply, ricks, sake, sharp, spare, time, times, wild
    • Replies: 2
    • Views: 1,892
    Last Post: 16th April 2001 08:08 PM
    by John Saxton  Go to last post
  11. Wet and Dry finishing

    Started by John Saxton, 29th August 2000 01:15 AM
    1200, begs, cheers, concerns, dry, electrical, employ, finish, finishing, grain, hardwoods, johnno, means, moisture, motors, paper, piece, rag, raise, rounding, soaking, spraying, utensil, wet, whilst
    • Replies: 0
    • Views: 1,507
    Last Post: 29th August 2000 01:15 AM
    by John Saxton  Go to last post
  12. MDF Health and Safety

    Started by StuPrice, 8th September 1999 10:37 PM
    actual, banned, clarify, concerns, cournties, exact, health, mdf, safety
    • Replies: 3
    • Views: 3,722
    Last Post: 10th September 1999 11:13 PM
    by StuPrice  Go to last post
Results 151 to 163 of 163
Page 4 of 4 1 2 3 4