Search:

Tag: doubler

Search: Search took 0.00 seconds.

  1. Goat - reinforcement below the transom tiller cutout?

    Started by Boatmik, 17th June 2010 07:09 PM
    boat, boats, box, cutout, design, doubler, drew, goat, goats, hits, incorporating, load, lot, means, mik, noticed, original, overlooked, peter, plan, ply, reason, reinforcement, rudder, setup, tiller, transom, update, usual
    • Replies: 6
    • Views: 1,977
    Last Post: 30th July 2010 11:06 PM
    by callsign222  Go to last post
  2. Hole Dimensions on Carba-Tec KS-12K Saw?

    Started by CeeTee, 14th March 2009 07:20 PM
    accurate, bolt, carba-tec, carbatec, ceetee, centre, diameters, dimensions, doubler, flat, front, hole, holes, ks-12k, ks12k, measure, measured, plate, results, steel, table, top, trust, wings
    • Replies: 0
    • Views: 1,086
    Last Post: 14th March 2009 07:20 PM
    by CeeTee  Go to last post
  3. Colour help required - urgent

    Started by Daddles, 25th March 2005 06:18 PM
    2 Pages
    1 2
    appreciated, blue, cheers, colour, coz, doubler, extend, floor, gunwale, gunwales, helpd, inside, inwale, inwales, knees, leave, notice, paint, plan, planking, rear, required, richard, shavings, sunday, tomorrow, top, transon, trim, urgent
    • Replies: 16
    • Views: 3,046
    Last Post: 28th March 2005 10:08 PM
    by Daddles  Go to last post
Results 1 to 3 of 3