Search:

Tag: encased

Search: Search took 0.01 seconds.

  1. Elegant Beauty Sierra

    Started by Les in Red Deer, 6th August 2014 09:33 AM
    400x, beauty, braided, brass, buffed, cast, elegant, encased, extra, fine, gloss, gold/black, huts, les, polished, polyester, resin, sand, sierra, steel, titanium, tube, ultra, wool
    • Replies: 2
    • Views: 1,650
    Last Post: 8th August 2014 12:16 PM
    by orificiam  Go to last post
  2. uses of woolibutt

    Started by scottmac, 24th April 2013 07:14 AM
    • Replies: 11
    • Views: 2,124
    Last Post: 30th April 2013 09:49 PM
    by scottmac  Go to last post

    Forum:
    TIMBER

  3. On off switch for table saws

    Started by Malcolm Eaton, 3rd December 2012 05:11 PM
    ago, appreciated, button, contact, cuts, eaton, encased, fault, green, hand, hick, hold, machinery, malcolm, perth, picked, purchase, push, range, red, rubber, saws, shroud, switch, switches, table, till, time, week
    • Replies: 4
    • Views: 1,449
    Last Post: 4th December 2012 10:23 PM
    by orraloon  Go to last post
  4. New shed termite protection

    Started by Kingfisher, 26th February 2012 07:34 PM
    ??mm, adjacent, ago, ants, blocked, blocking, dirt, drilled, encased, extension, fabric, ground, holes, house, leaches, nasty, pipe, pouring, prior, protection, rose, shed, similar, slab, sleeve, stop, system, termite, walls, white
    • Replies: 12
    • Views: 4,998
    Last Post: 29th March 2012 05:27 PM
    by ch!ppy  Go to last post

    Forum:
    THE SHED

  5. Meat Safe

    Started by wheelinround, 30th September 2011 10:33 AM
    box, cure, curing, curing/seasoning, encased, for-, including, meat, mils, neighbour, pass, prior, project, question, safe, salt, seasoning/curing, sold, space, timbers, time, yesterday
    • Replies: 7
    • Views: 1,550
    Last Post: 2nd October 2011 10:31 AM
    by wheelinround  Go to last post

    Forum:
    BOX MAKING

  6. BA Falcon Front Hub

    Started by smidsy, 23rd March 2011 08:13 PM
    255nm, changed, device, encased, falcon, flimsy, front, holding, housing, hub, independant, individual, locking, lot, manual, mechanism, nut, nuts, peel, pretty, remove, single, sort, thin, torque, unit
    • Replies: 0
    • Views: 2,175
    Last Post: 23rd March 2011 08:13 PM
    by smidsy  Go to last post
  7. Fresh spotted gum trunks for structural posts?

    Started by Reno RSS Feed, 18th October 2010 08:20 PM
    base, chopped, concrete, corner, cubby, deck, dry, effect, elevated, eliminate, encased, excuse, expect, fresh, gum, houses, issues, minimise, note, posts, read, renovateforum.com, repost, spotted, structural, thread, thx, tree, trunks, waiting
    • Replies: 0
    • Views: 1,143
    Last Post: 18th October 2010 08:20 PM
    by Reno RSS Feed  Go to last post
  8. Plane storage ideas

    Started by rsser, 25th January 2010 02:06 PM
    4 Pages
    1 2 3 4
    2nd, buying, closer, encased, hand, ideas, nooks, north, paw, plane, planes, read, reduce, savings, shed, splint, storage, stored, systematic, wallspace, welcomed
    • Replies: 56
    • Views: 13,777
    Last Post: 1st April 2010 10:39 AM
    by IanW  Go to last post
  9. How to allow for timber shifting?

    Started by Paulphot, 5th February 2010 06:44 PM
    adding, allowing, ash, board, chopping, contract, edge, edges, edging, encased, expand, glueing, grain, gurus, main, merbau, oak, paul, pieces, run, sealing, shifting, spots, tassie, timber
    • Replies: 8
    • Views: 1,252
    Last Post: 7th February 2010 08:19 AM
    by RufflyRustic  Go to last post
  10. Robust finish for conference table

    Started by MarkInBoatshed, 18th August 2009 02:06 PM
    assure, beautiful, business, colour, compromised, conference, encased, fantastic, finish, floor, furniture, harder, mark, minwax, plastic, poly, polyurethanes, preferably, product, red, robust, satin, sealer, soft;, suggestions, table, waterproof;, whatsoever, wipe-on, wood
    • Replies: 5
    • Views: 1,273
    Last Post: 24th August 2009 12:53 PM
    by MarkInBoatshed  Go to last post

    Forum:
    FINISHING

  11. Sun Lounge

    Started by smidsy, 13th June 2009 01:10 PM
    120x45, 45x90, bolt, chain, cheers, designs, encased, extended, flex, frame, hei, ideas, issues, itwould, join, joint, lounge, lying, mechanism, motorbike, paul, pin, recliner, simple, steel, stuff, sun, system, tubing, wear
    • Replies: 0
    • Views: 1,402
    Last Post: 13th June 2009 01:10 PM
    by smidsy  Go to last post
  12. transom replacment

    Started by sicberg, 27th December 2008 03:44 PM
    140, advise, british, dan, dollars, encased, experiance, fibreglass, hav, hope, issue, marine, ply, quality, replaced, replacing, replacment, sheet, speedboat, suitable, transom, type
    • Replies: 4
    • Views: 2,329
    Last Post: 28th December 2008 11:22 AM
    by Darce  Go to last post
  13. water feature

    Started by fubar, 29th November 2008 08:15 AM
    $41.00, $50.00, 200lt, 4.5, 90x20, basically, black, bonus, bunnings, cost, decking, encased, feature, framing, front, happy, hours, merbau, offcuts, result, resulted, scrap, shed, shes, swmbo, timber, tub, verandah, water
    • Replies: 2
    • Views: 1,443
    Last Post: 30th November 2008 11:44 AM
    by flynnsart  Go to last post
  14. Aluminium Sash window repairs

    Started by ubeaut, 16th November 2008 07:21 AM
    aluminium, appears, assembleys, coil, counter, encased, fathom, fixed, moving, plain, plastic, repair, repairs, replace, runs, sash, shaft, spring, tube, twisted, weight, white, window, windows, yrs
    • Replies: 0
    • Views: 7,280
    Last Post: 16th November 2008 07:21 AM
    by ubeaut  Go to last post
  15. Paper brick maker - Logmaker-Australia launch

    Started by logmaker-austra, 2nd June 2008 05:40 PM
    barbecue, brick, burn, burning, camp, chiminea, compact, contents, depending, encased, fire, garden, hour, household, launch, logmaker-australia, logmakeraustralia, machines, maker, minutes, newspaper, paper, people, produce, sell, stove, straight, waste, wood, ‘logs’
    • Replies: 0
    • Views: 12,657
    Last Post: 2nd June 2008 05:40 PM
    by logmaker-austra  Go to last post
  16. Decking Posts Rotting

    Started by benny56, 30th January 2007 02:18 PM
    1994, abviously, base, benny56, build, building, caused, clearing, concrete, deck, decking, directly, encased, erected, fixing, forum, found, ground, moisture, pine, post, posts, retreating, rotting, rubbish, severe, solution, thinking, treated, water
    • Replies: 7
    • Views: 3,552
    Last Post: 31st January 2007 02:38 PM
    by MurrayD99  Go to last post
  17. Expanding Dining Table - any tips?

    Started by craigb, 20th January 2007 02:04 PM
    article, banding, bothers, cheers, craig, crosswise, dining, drawer, edge, encased, endgrain, expanding, expansion, experiences, feel, free, fww, grain, jump, means, run, seater, slides, slightly, sort, suppose, table, timber, tips, top
    • Replies: 9
    • Views: 2,710
    Last Post: 22nd January 2007 09:21 AM
    by craigb  Go to last post
  18. racal respirator battery??

    Started by aljenit, 5th October 2005 09:44 AM
    $1000+, ?1985, archives, battery, confused, cost, dollars, dust, encased, filled, helpful.thank, hour, joins, land, living, mind, option, pack, plastic, racal, read, repacking, replacing, respirator, super, thick, type, unit, visible, worth
    • Replies: 3
    • Views: 2,083
    Last Post: 5th October 2005 09:58 PM
    by Harry72  Go to last post
  19. Glass storage for scary sharp

    Started by Redback, 21st March 2005 06:37 PM
    2 Pages
    1 2
    bench, completely, dry, encased, flat, glass, glue, grit, harms, level, lid, mdf, note, piece, plane, process, progress, recess, router, sandpaper, scary, sharp, sit, storage, technique, thinking, top, type, wet, woulb
    • Replies: 18
    • Views: 3,362
    Last Post: 22nd March 2005 04:53 PM
    by outback  Go to last post
  20. WOODWORKING quiz FOR 14 Oct 04

    Started by Ralph Jones, 14th October 2004 09:37 PM
    108, 4/4, acclimated, action, boards, close, day, encased, evening, found, friends, ingrown, knot, knots, looked, loose, oct, planer, poplar, quiz, received, respectfully, run, shop, week, woodworking
    • Replies: 4
    • Views: 1,290
    Last Post: 15th October 2004 09:44 PM
    by Ralph Jones  Go to last post
Results 1 to 20 of 21