Search:

Tag: oz-in

Search: Search took 0.00 seconds.

  1. Planning my first CNC machine

    Started by grunto, 23rd November 2009 11:20 AM
    1/4, 115/230v, 300, 387, 48v, 540, 7.3a, axis, cnc, controller, diameter, gecko, kl-350-48, kl23h284-35-4b, lead, machine, motor, motos, oz-in, planning, power, rail, rails, screw, screws, stepper, suit, support, supported, units 1 Attachment(s)
    • Replies: 4
    • Views: 3,314
    Last Post: 16th November 2018 06:28 PM
    by grunto  Go to last post

    Forum:
    CNC Machines

  2. My first DIY machine

    Started by sjm, 22nd April 2012 04:58 PM
    $12, $40, $47, $55, $60, $90, all-thread, bearings, board, bom, computer, controller, couplers, diy, included, keypad, linear, machine, moment, motors, nema17, oz-in, playing, power, quick, rails, sliding, software, supply, supported
    • Replies: 3
    • Views: 1,764
    Last Post: 26th April 2012 11:42 AM
    by sjm  Go to last post

    Forum:
    CNC Machines

  3. cnc router planning stage

    Started by Donkey, 31st August 2009 07:26 PM
    2 Pages •
    1 2
    1200mm, 425, acrylic, advance, bench, cnc, cutting, decent, decorating/edging, dremel, engraving, info, jsut, laminate, motor, move, nema, oz-in, pine, planning, post, power, router, speed.plan, stage, stepper, table, trimmer, wondering
    • Replies: 18
    • Views: 2,703
    Last Post: 2nd September 2009 12:20 PM
    by rodm  Go to last post

    Forum:
    CNC Machines

  4. Motors for a large gantry

    Started by Ch4iS, 10th November 2008 11:00 PM
    2 Pages •
    1 2
    $1000, 1200oz-in, 425, 425s, 5/16, axis, bore, budget, build, bunch, dual, gantry, gecko, kit, large, motors, nema, opinions, oz-in, pulleys, question, reduction, reductions, run, running, source, suffice, supplier, ultimate, xyoltex
    • Replies: 17
    • Views: 4,189
    Last Post: 13th November 2008 10:35 PM
    by niall  Go to last post

    Forum:
    CNC Machines

Results 1 to 4 of 4