Search:

Tag: parallels

Search: Search took 0.00 seconds.

  1. A question?

    Started by th62, 22nd May 2013 05:15 PM
    .02mm, 100mm, aft, angle, bed, blanks, carriage, carriages, difference, fore, i’ve, lathe, level, levelled, measurable, method, other;, parallels, question, remains, run, set, slight, square, time, times, tool, unsupported, untwisted, wider
    • Replies: 4
    • Views: 1,164
    Last Post: 23rd May 2013 11:33 AM
    by th62  Go to last post

    Forum:
    METALWORK FORUM

  2. 1-2-3 Blocks as Parallels?

    Started by simonl, 5th May 2013 05:06 PM
    3 Pages •
    1 2 3
    0.0002, arrive, australia, bed, blocks, buy, cheers, claim, electronics, fashion, hand, home, intend, lathe, level, leveling, machinists, matched, pair, parallels, placing, plate, purchased, rest, scraping, setting, simon, surface, tiny, verify 1 Attachment(s)
    • Replies: 41
    • Views: 3,776
    Last Post: 10th May 2013 08:15 PM
    by simonl  Go to last post

    Forum:
    METALWORK FORUM

  3. Milling Parallels

    Started by Oldneweng, 28th January 2013 11:07 AM
    added, base, basic, bear, bought, buy, carry, cleaned, comments, dean, easier, exotic, finally, fine, idea, inch, mill, milling, mind, oiled, parallels, setting, similar, slightly, thinking, time, trammelling, vertex, vice, xmas
    • Replies: 8
    • Views: 1,530
    Last Post: 31st January 2013 05:29 PM
    by Oldneweng  Go to last post

    Forum:
    METALWORK FORUM

  4. Lathe Stop

    Started by Stustoys, 29th January 2011 10:11 PM
    2 Pages •
    1 2
    book, clean, complete, covering, direction, finished, fwd, inside, job, lathe, lift, luck, milling, page, paper, parallels, phone, picked, piece, pitch, ready, reverse, run, screw, stop, switch, thread, trusted, vice, wire
    • Replies: 21
    • Views: 3,242
    Last Post: 16th March 2011 06:44 PM
    by Stustoys  Go to last post

    Forum:
    METALWORK FORUM

  5. fitter and machinist

    Started by the fabricator, 15th January 2010 08:41 PM
    2 Pages •
    1 2
    500mm, advance, apprenticeship, apprenticeships, bench, blocks, centre, classes, fitter, fitters, fitting, guys, hey, job, kit, laths, lol, machine, machining, machinist, machinists, micrometres, parallels, rewarding, schoolwork, set, start, tafe, tools, vee
    • Replies: 23
    • Views: 3,420
    Last Post: 23rd January 2010 12:31 PM
    by gallegos  Go to last post

    Forum:
    METALWORK FORUM

Results 1 to 5 of 5