Search:

Tag: steadys

Search: Search took 0.00 seconds.

  1. mcmillan ml 24

    Started by welder, 26th July 2011 07:05 PM
    4 Pages •
    1 2 3 4
    $1500, backlash, bed, buying, chucks, condition, gst, guy, hercus, impeccable, inch, lathe, mcmillan, ml24, replace, replacment, screws, standard, steadys, thinking, wear
    • Replies: 59
    • Views: 7,937
    Last Post: 1st November 2011 08:34 PM
    by welder  Go to last post

    Forum:
    METALWORK FORUM

  2. Travelling steady for a B model Qualos

    Started by Metmachmad, 16th January 2011 08:58 AM
    3 Pages •
    1 2 3
    adapt, b model, bought, finding, fixed, forum-, graveyard, hunt, i.e, incidently, lathe, lathes, lost, luck, makers, mid, model, procur, provide, qualos, questions, rigidity, seeking, separated, steady, steadys, support, thinking, travelling, virtual
    • Replies: 34
    • Views: 4,537
    Last Post: 2nd September 2011 11:49 PM
    by Stustoys  Go to last post

    Forum:
    METALWORK FORUM

  3. Made myself a 3 point steady.

    Started by JDarvall, 28th January 2008 05:06 PM
    10mm, bearing, bit, bolt, bring, clamped, closer, detail, drill/tap, fence, fit, gist, groove, happy, holes, idea, lower, point, rod, rods, rout, skateboard, slide, spindles, steady, steadys, thin, thinking, tools, whip
    • Replies: 14
    • Views: 3,185
    Last Post: 30th January 2008 06:28 AM
    by JDarvall  Go to last post

    Forum:
    WOODTURNING - GENERAL

  4. very long and thin

    Started by weisyboy, 15th August 2007 06:51 PM
    24mm, 500mm, 850, angle, center, corsest, couple, disk, fast, finished, grinder, hand, lathe, length, long, mounted, peice, roughed, sanded, simple, slowest, smoth, speed, stabaliing, started, steadys, supot, thick, thin, treat
    • Replies: 4
    • Views: 1,558
    Last Post: 16th August 2007 09:19 AM
    by weisyboy  Go to last post

    Forum:
    WOODTURNING - GENERAL

  5. Anyone bought or made a "center steady for a lathe????

    Started by Rowan, 24th April 2006 06:15 PM
    2 Pages •
    1 2
    archives, bearings/wheels, bought, center, chatter, commercially, cws, day, decided, eggs, finish, firmly, found, harder, hold, joy, lathe, looked, middle, minimise, movement, piece, pointers, search, site, steady, steadys, surround, teknatool, wood
    • Replies: 16
    • Views: 4,374
    Last Post: 5th May 2006 10:52 AM
    by ptc  Go to last post

    Forum:
    WOODTURNING - GENERAL

Results 1 to 5 of 5