Search:

Tag: stresses

Search: Search took 0.00 seconds.

  1. Bbandsaw advice please

    Started by tony_A, 28th July 2016 04:28 PM
    2 Pages •
    1 2
    adjoining, advice, appreciated, bandsaw, breaking, cast, centre, comments, confirmed, cooled, current, dogie, experiences, gumtree, heard, heated, mark, owner, scary, seller, silver, slowly, spokes, stresses, time, tony, top, welding, wheel, wheels
    • Replies: 20
    • Views: 12,502
    Last Post: 1st August 2016 12:29 AM
    by auscab  Go to last post

    Forum:
    ANTIQUE AND VINTAGE MACHINERY

  2. Log Tension by Timboz

    Started by timboz, 19th February 2014 03:43 PM
    4 Pages •
    1 2 3 4
    absolute, amount, band, cells, centre, change, comments, distance, distances, gradient, log, low, maximum, movement, negative, occurs, positive, rate, rubber, size, spring, stress, stresses, stretched, tension, tensioned, timboz, tree, trees, trunk 6 Attachment(s)
    • Replies: 48
    • Views: 9,707
    Last Post: 21st November 2014 01:23 AM
    by rwthom279  Go to last post

    Forum:
    SMALL TIMBER MILLING

  3. Axle question please

    Started by whitey56, 14th November 2013 09:16 AM
    100mm, appreciated, axle, axles, center, clearance, compared, complaints, fit, fix, gain, hangers, hard, leaf, mounts, paul, position, question, rear, rta, semi-trailer, semis, set, springs, stops, stresses, underslung, vans, [2]
    • Replies: 3
    • Views: 2,069
    Last Post: 16th November 2013 07:05 AM
    by whitey56  Go to last post

    Forum:
    TRAILERS & OTHER FABRICATED STUFF

  4. sealing wet silky oak

    Started by mick59wests, 17th June 2012 07:32 PM
    ago, alleviate, amount, appreciated, asap, avoid, cracks, cut, days, experienced, greatly, ground, hoping, logs, mick, oak, picked, pieces, rain, reasonable, sealing, silky, split, stacked, stored, stresses, time, water, wet, wise
    • Replies: 2
    • Views: 2,049
    Last Post: 22nd June 2012 06:08 PM
    by mick59wests  Go to last post

    Forum:
    TIMBER

  5. help please woodbending

    Started by BenBrown, 25th April 2012 03:53 PM
    10-20mm, 19mm, 25-30mm, 50mm, air, appreciated, approx, awhile, bent, bounced, braces, finished, fix, greatly, guinea, jig, middle, p.s, plank, rosewood, rough, size, straight, stresses, suggestions, table, tapered, thick, timber, woodbending
    • Replies: 7
    • Views: 1,692
    Last Post: 27th April 2012 12:52 AM
    by BenBrown  Go to last post

    Forum:
    WOODWORK - GENERAL

  6. Predicting amount of distortion in timber

    Started by Tiger, 5th December 2011 12:37 PM
    amount, bandsaw, behave, bow, cut, distortion, dress, due, fairly, internal, moment, pine, predict, predicting, purchasing, purposes, radiata, realise, recutting, released, remain, resawing, results, selective, slabs, stresses, studs, telling, timber, variable
    • Replies: 4
    • Views: 1,393
    Last Post: 6th December 2011 08:57 AM
    by IanW  Go to last post

    Forum:
    TIMBER

  7. Bandsaw blades

    Started by sfrew, 7th February 2011 12:00 AM
    .they, 100mm, 2nd, bandsaw, blade, blades, blame, bought, broken, cheers, circle, ease, figure, formation, fractures, hand, hardware, introduce, lesson, person, product, putting, replacement, ryobi, steveroll, store, stresses, transport, transported, wondering
    • Replies: 2
    • Views: 2,027
    Last Post: 10th February 2011 09:28 PM
    by elanjacobs  Go to last post

    Forum:
    BANDSAWS

  8. Aaaghhh - oz. red cedar bent after cutting

    Started by deldridg, 16th November 2009 03:42 PM
    30mins, aaaghhh, allowing, bent, bit, boards, cedar, clamp, cut, cutting, damage, david, dry, expensive, figured, gun, hehe, hot, learning, piece, red, released, sad, shy, soak, straight, stresses, stuff, water, weeks
    • Replies: 8
    • Views: 1,577
    Last Post: 18th November 2009 01:51 PM
    by deldridg  Go to last post

    Forum:
    WOODWORK - GENERAL

  9. Delta saw failing

    Started by Treecycle, 29th October 2009 10:01 PM
    36-600, accelerate, ago, belt, brought, couple, dallas, delta, enormous, failing, firewood, half, hand, immediately, lot, mine, motor, rate, replace, replaced, saws, softer, speed, start, stresses, switch, teeth, timing, wood, wrong
    • Replies: 0
    • Views: 1,993
    Last Post: 29th October 2009 10:01 PM
    by Treecycle  Go to last post

    Forum:
    TABLE SAWS & COMBINATIONS

  10. Metal Fastenings - yes or no?

    Started by SimonP, 17th May 2009 10:09 AM
    2 Pages •
    1 2
    boat, completely, construction, due, edition, eliminated, elimination, embalmed, epoxy, essentially, fastenings, glass, glues, hold, lends, magazine, march/april, metal, p33, paint, plank/panel-on-frame, rely, shrinking, situations, soaked, stresses, swelling, technique, timber, wooden
    • Replies: 19
    • Views: 2,711
    Last Post: 19th May 2009 10:14 PM
    by PAR  Go to last post

    Forum:
    BOAT BUILDING / REPAIRING

  11. Oz PDR build in Adelaide - sexy black PDRacer

    Started by m2c1Iw, 6th April 2008 09:56 PM
    3 Pages •
    1 2 3
    20mm, adelaide, advise, bit, black, build, built, consideration, cutting, day, decided, destination, frame, grain, lack, lost, pdr, pdracer, pieces, plans, ply, progress, result, sexy, short, spare, staring, stresses, time, total 1 Attachment(s)
    • Replies: 39
    • Views: 19,884
    Last Post: 27th April 2009 06:30 PM
    by m2c1Iw  Go to last post

    Forum:
    Michael Storer Wooden Boat Plans

  12. Badly bowed decking boards

    Started by Reno RSS Feed, 21st January 2009 05:10 PM
    4.8m, attempt, attempts, bend, boards, compared, cracked, dave, days, deck, decking, edge, eleviate, frame, grain, hope, length, method, people, read, renovateforum.com, rest, special, straight, straighten, stresses, suck, thread, wet, width
    • Replies: 0
    • Views: 2,290
    Last Post: 21st January 2009 05:10 PM
    by Reno RSS Feed  Go to last post

    Forum:
    RENOVATE FORUM RSS FEED

  13. Cracks in Blue Gum

    Started by dai sensei, 20th December 2008 08:14 PM
    afternoon, bad, bit, blanks, blue, cheers, common, cracks, cut, due, excavator, forks, gap, grain, gum, learning, luck, moved/broken, pens, rough, seal, sealed, sealer, stacked, storm, stresses, time, tracked, tree, xmas
    • Replies: 7
    • Views: 2,189
    Last Post: 28th December 2008 02:20 PM
    by weisyboy  Go to last post

    Forum:
    TIMBER

  14. Symmetry and the acoustic guitar

    Started by Different, 25th August 2008 04:55 PM
    3 Pages •
    1 2 3
    acoustic, aesthetic, bridges, call, centre, guitar, guitars, historical, induced, instrument, line, note, produced, reasons, regonomics, ross, sound, stresses, symmetrical, symmetry
    • Replies: 30
    • Views: 8,056
    Last Post: 27th September 2008 01:58 AM
    by pugwash  Go to last post

    Forum:
    MUSICAL INSTRUMENTS

  15. Modifications to a Whilly Boat

    Started by Paul A Atkins, 27th March 2008 10:24 PM
    2 Pages •
    1 2
    additional, board, boat, center, chance, chopping, class, cockpit, cover, fingers, impossible, kids, michael, minimise, modifications, plate, protection, pull, push, sail, slot, stick, stresses, swapping, thinking, treat, weight, weighted, whilly, yoke
    • Replies: 17
    • Views: 14,870
    Last Post: 31st March 2008 08:53 AM
    by Boatmik  Go to last post

    Forum:
    Michael Storer Wooden Boat Plans

  16. How would you mount this?

    Started by Skew ChiDAMN!!, 30th June 2007 01:04 AM
    2 Pages •
    1 2
    ballnsocket, blank, bowl, bowls, centres, chuck, close, deep, end-hollowing, fit, half, idea, ideas, jam, jam-chuck, moment, mount, mounting, naught, planning, rolleyes, sat, secure, shape, sort, stand, stem, stresses, thankyouverymuch, tightly
    • Replies: 20
    • Views: 3,520
    Last Post: 5th July 2007 03:24 AM
    by Skew ChiDAMN!!  Go to last post

    Forum:
    WOODTURNING - GENERAL

  17. Heat treating very thin blades

    Started by derekcohen, 4th June 2007 12:04 AM
    2 Pages •
    1 2
    alternative, blade, blades, brittle, chisels, damage, derek, determine, downside, duration, edge, feeling, half, hard, heat, issue, lock, permits, perth, planes, roughly, steel, stresses, subjected, temper, temperature, tempering, treated, treating, vulnerable
    • Replies: 21
    • Views: 3,679
    Last Post: 5th June 2007 01:35 AM
    by BobL  Go to last post

    Forum:
    METALWORK FORUM

  18. timber for roof rack

    Started by rat52, 1st June 2007 02:11 PM
    $150.00, assemble/weld, bearing, brackets, confident, demountable, elongating, flexing, front, holes, house, idea, load, loads, period, ply, rack, racks, rear, roof, screws, shed, shift, shifting, steel, stresses, term, timber, underneath, ute
    • Replies: 0
    • Views: 1,451
    Last Post: 1st June 2007 02:11 PM
    by rat52  Go to last post

    Forum:
    WOODWORK - GENERAL

  19. Laminated Beams

    Started by rmm1, 22nd March 2006 04:02 PM
    18mm, 20ft, 500, 600, about18, advice, authority, beams, boat, build, carry, caution, cross-sectional, err, gratefully, inspection, kilos, laminated, local, pass, prefer, received, replies, seek, strains, stresses, transport, weigh, weight
    • Replies: 9
    • Views: 3,072
    Last Post: 23rd March 2006 07:23 PM
    by rmm1  Go to last post

    Forum:
    WOODWORK - GENERAL

  20. Poor Quality Issue - advice needed.

    Started by Groggy, 29th May 2005 12:10 PM
    advice, attempt, cutting, dry, feel, guess, humidity, issue, late, needed, panel, picture, poor, purchase, quality, repair, return, stable, stored, stresses
    • Replies: 13
    • Views: 2,466
    Last Post: 20th August 2005 08:17 AM
    by Munga  Go to last post

    Forum:
    WOODWORK PICS

  21. Silky Oak in hull construction?

    Started by delamaree, 16th June 2005 09:56 PM
    1952, built, considered, construction, delamaree, excellent, hiya, hull, inch, ketch, knowledge, oak, plank, planned, shape, silky, stresses, timber
    • Replies: 2
    • Views: 3,958
    Last Post: 16th June 2005 10:58 PM
    by Waitey  Go to last post

    Forum:
    BOAT RESOURCES / PRODUCT SEARCH

  22. Bowsaw

    Started by derekcohen, 31st May 2005 12:45 AM
    $69, afraid, american, artistic, bandsaw, blade, bowsaw, build, burned, cut, electrons, enjoyed, found, hold, inspired, i’m, lathe, license, oak, perth, picture, piece, pieces, spokeshave, spokeshaves, stresses, suppose, timber, time, tools
    • Replies: 10
    • Views: 3,672
    Last Post: 1st June 2005 02:43 PM
    by IanW  Go to last post

    Forum:
    Saws- handmade

  23. Seasons Greetings

    Started by derekcohen, 20th December 2004 08:47 PM
    access, advice, chatting, computer, couple, days, dear, derek, festive, forward, heading, holiday, letting, meeting, opportunity, past, patience, patient, person, perth, providing, respite, seasons, sprout, stresses, support, weeks, wife, workshop, world
    • Replies: 11
    • Views: 1,713
    Last Post: 22nd December 2004 11:09 AM
    by Barry_White  Go to last post

    Forum:
    WOODWORK - GENERAL

Results 1 to 23 of 23