Search:

Tag: twine

Search: Search took 0.00 seconds.

  1. So Where To Next, The Motor Rewinder?

    Started by Anorak Bob, 5th April 2014 08:29 PM
    10 Pages •
    1 2 3 4 5 6 7 8 9 10
    309404, alan, bob, c-47, capital, copper, cutter, dealt, dig, digging, grinder, housing, light, minus, motor, no.1, perth, postable, replace, rewinder, rewinders, rotor, simons, stuff, suggestions, sweetmans, tool, twine, unravel, wire 69 Attachment(s)
    • Replies: 140
    • Views: 12,771
    Last Post: 27th April 2014 04:02 PM
    by BobL  Go to last post

    Forum:
    METALWORK FORUM

  2. Take a bow

    Started by enelef, 16th December 2013 07:37 PM
    2 Pages •
    1 2
    297506, 5/16, bit, bits, bolts, bow, brass, cedar, change, cord, cotton, cut, fibres, happy, hear, highish, holding, jute, locking, looked, overly, piece, ready, rope, sanding, sash, tension, threw, twine, unit 12 Attachment(s)
    • Replies: 15
    • Views: 3,208
    Last Post: 30th December 2013 03:53 AM
    by Robson Valley  Go to last post

    Forum:
    HOMEMADE TOOLS AND JIGS ETC.

  3. Installing inset drawer faces process

    Started by Dewayne, 9th October 2008 04:40 PM
    1/8, box, built, carpet, challenge, consistent, cord, door, double, drawer, faces, gap, holds, inset, installing, process, pulling, purpose, removed, screws, secured, set, shims, solve, stick, success, tape, target, temporarily, twine
    • Replies: 7
    • Views: 2,659
    Last Post: 15th October 2008 04:19 PM
    by pugwash  Go to last post

    Forum:
    WOODWORK - GENERAL

Results 1 to 3 of 3